• Advanced electronic controller
• Custom microprocessor

Note: Heating Trays have a 1.75" center-to-center measurement when put side by side.

Acrylics, ABS, Polypropylene,
Polyethylene, PVC, Polycarbonate
. . . and many more

This Heating System prepares all types of thermoplastic materials for forming all-angle bends and reduces fabrication time both in set-up and multiple bend operations. Simple and durable. The plastic does not come in contact with the heating element. Unit is equipped with four independently operated and movable heating trays. Index rules on either side of table allow for precise measurements. Full usage of working area allows you to work from both sides of the table at the same time. The adjustable fence/stop may be positioned as shown or between trays. Simply lay your plastic material on top of the trays; elements are recessed and trays are Teflon-coated to provide professional results. Units are completely self-contained and require no special wiring.

• Each Heating Tray is individually controlled.
• Main ON/OFF switch.
• Individual power indicator light for each tray.
• Bult-in line voltage detection
• Bult-in 3-function timer
• Low voltage warning
• Large digital display

Electrical Information

• Input Voltage 120V AC, 60Hz
• Maximum Load 120V - 1800 watts
• Voltage Control Range 0 to 120 volts
• Control Mode Solid State Phase Angle

• Outside Dimensions:
• 62" Wide x 54" Deep x 5" High
• Inside Dimensions:
• 48" Wide x 48" Deep working area
• 68/lbs approximate assembled weight

• 1700°F ultra hi-temperature.
• Heat treated to reduce stress.
• Sealed and Teflon-coated working surface.
• Heating Elements
• Elements are computer profiled for precise heating
• Maximum operating temperature of 800°F.
• .315" Diameter elements on Model #48-48E.
• .165" Diameter elements on Model #48-48E/4

Model Usage Guide for Material Thickness
 48-48AEC 1/8" and thicker material.
 48-48AEC/4 .100" and thinner material

Custom designs also available

Note: Additional Power Control (AEC-15)